Light Wire Forming Plier with Cutter (2 Grooves at Tip)

Tips are constructed with a thin tapered round and square beak; two grooves are placed at the tip and are accompanied by an anvil wire cutter at the rear of the beak. The grooves are placed 1 mm and 2 mm back from the tip on the flat side. The cutter at the rear of the beak is capable of cutting round and rectangular wire up to .025" diameter and .019" x .025" saving time and motion with the added cutter. Both beaks are manufactured with hardened steel inserts to help eliminate slippage during use which also creates a stronger longer lasting instrument.

• Both round and square beaks measure .025" inches allowing sharp tight bend and helixes.
• Two grooves are placed 1 mm and 2 mm back from the tip on the flat side.
• The grooves help secure an arch wire when bending loops.
• Towards the rear of the tip is a built in anvil cutter capable of cutting all arch wire up to .025" diameter and .019" x .025" round and rectangular.
• Hardened steel inserted tips are soldered at the tip to increase the strength of the instrument and help eliminate slippage when forming or bending wire.
• The round portions of the beaks are machined to achieve a tight smooth bend and helix during chair side operation.
• Recommended for round and rectangular wire up to .025" diameter and .019" x .025".
• All stainless steel box joint construction accommodated by a hardened steel inserted tip for strength.